Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the pro arrives.
Get your free estimateTrusted Garage Door Spring Repair for Centreville Homeowners
A broken spring shows up fast and loud: a bang from the garage, a door that won’t lift, a car stuck inside on a work morning. A torsion spring is the part that carries the door’s weight, and once it snaps, the opener can’t move that weight on its own. We handle torsion and extension spring jobs across Centreville, including same-day calls when a door is jammed open. Our technicians have up to 14 years of experience, so they read the wear pattern, test the balance, and replace the spring that actually failed. Call (855) 497-3217 and we’ll get a trained technician to the door.

What Our Garage Door Spring Repair Service Includes
Spring work on a garage door is a narrow, technical job. Every service below is done on the door’s own spring system, measured for that door, and priced before the technician unloads a single tool.
Torsion Spring Replacement
A torsion spring is the coiled spring mounted on the shaft above the door, and it does the lifting work when the door opens. You need replacement when the coil has broken, gone slack, or stopped holding the door’s weight evenly. We fit a spring rated for your door’s weight and height, then balance the door so the opener isn’t fighting a load it was never built for.
Extension Spring Replacement
Extension springs run along the horizontal tracks on each side and stretch to lift the door. They fail most often at the end loops, which can leave a door hanging crooked or half open. We replace them in matched pairs with the correct capacity, then check the door travels true through the whole cycle.
Broken Spring Repair
When a spring breaks mid-travel, the door can drop or lock in place, and the opener may keep grinding against a dead load. You need this service the moment you hear the snap or see a visible gap in the coil. We confirm the break, check for any damage it caused to cables or tracks, and get the door moving properly again.
Spring Adjustment
Adjustment tightens or sets the spring tension so the door lifts with light effort and closes under control. Doors that drift down a few inches when released, or that need a hard shove to start, usually need this. We dial the tension in by feel and by test, since guessing at turns is how people break springs.
Safety Cable Installation
Safety cables thread through extension springs so the spring can’t whip loose if it fails. Every extension spring we replace gets cables with it, because a bare spring is a genuine hazard to anyone standing in the garage. This is a small part of the job with a big safety payoff.
Spring Inspection
A spring inspection looks for the early signs: stretching, rust at the coil, a slight bow, or a door that suddenly feels heavier. We test the balance and check the hardware the spring attaches to, since a worn center bearing or loose drum can mimic a spring problem. If nothing’s wrong, we tell you that instead of selling you a spring you don’t need.
If you want the full rundown of this service, see our garage door spring repair page.
Styles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
Brands We Service for Garage Door Spring Repair
We work on Raynor and Clopay doors and the LiftMaster, Chamberlain, and Genie opener systems that drive them, and the spring setup inside each one behaves a little differently. A Raynor door built with a specific drum-and-shaft arrangement wears in a way that a generic spring swap doesn’t account for. A Clopay door may use a torsion setup that needs close attention to cable tension once the new spring goes on. Knowing the door before you touch it saves the second visit.
On the opener side, a LiftMaster or Chamberlain unit will strain differently than a Genie when a spring goes weak, and one may trip its safety reverse while the other just works harder and heats up. We read that behavior as a clue to the spring’s condition, not a reason to replace an opener that’s fine. Whether you have a Raynor, a LiftMaster, a Chamberlain, a Genie, or any other make, we can help.
Signs You Need Garage Door Spring Repair Right Now
- A loud bang from the garage. That sharp report is usually a torsion spring breaking, often while the door is at rest. If you heard it, don’t run the opener again until someone looks at it.
- The door won’t open, or opens a few inches and stops. A dead spring leaves the opener trying to lift weight it can’t handle. Grinding on it stresses the opener motor and the door hardware.
- The door feels very heavy when you lift it by hand. A balanced door should rise with light effort. If you’re straining, the spring has lost its lift and you should stop testing it.
- A visible gap or separated coil in the spring. You can often see the break as a clean gap in the coil or a stretched-out section. That’s a confirmed failure, not a warning.
- The door drops partway or closes hard. A door that slams or drifts down after you let go has weak or uneven tension. It’s a control problem that leads to hardware damage if you leave it.
Our Garage Door Spring Repair Process – Step by Step
- 1
We identify the spring system. The technician checks whether the door runs torsion or extension springs, notes the brand and door weight rating, and matches the replacement to it. Springs are rated by capacity, so the wrong size either strains the opener or leaves the door hard to balance.
- 2
We make the door safe to work on. Torsion springs hold real stored energy and aren’t something to handle without the right winding bars. The technician secures the door, winds the tension off properly, and removes the old spring with control. This is exactly the step where a DIY attempt can cause a serious injury.
- 3
We install the new spring and hardware. The replacement goes on with the correct cables and drums in place, and extension springs get safety cables as standard. We check every fastener the spring loads, since a loose center bearing or worn drum will undo a good spring.
- 4
We balance the door and test the cycle. The door is run open and closed several times, tension is set so it moves smoothly, and the safety reverse is tested. A door that’s properly balanced takes the load off the opener for years.
- 5
We show you what we found. Before we leave, the technician walks you through what failed, what was replaced, and anything to watch on the door going forward. No surprises on the invoice, because the price was agreed before we started.
See the difference
Before
After
Before
After
Before
AfterHow Much Does Garage Door Spring Repair Cost in Centreville?
Garage door spring repair in Centreville typically runs $180 – $340 for one spring, and that range covers the common torsion and extension replacements. A matched pair is usually replaced together, so a pair costs about twice that. Here’s how the numbers break down by job:

| Service | Typical Estimated Range |
|---|---|
| Spring repair (one spring) | $180 – $340 |
| Matched pair of springs | about $360 – $680 |
| Cable repair | $130 – $250 |
| Track realignment | $120 – $240 |
| Roller replacement | $110 – $220 |
What affects the price: whether it’s one spring or a pair, torsion versus extension, the door’s height and weight, and whether a broken spring damaged cables or drums along the way. Tracks and rollers are separate line items if they need attention.
To avoid overpaying, ask for the price before the work starts and confirm what’s included (spring, cables, balance check). Our estimate is free, and the written quote is the price you pay. If the technician finds something more once the door is open, you’ll hear it before anything is done, not on the bill. Call (855) 497-3217 for an exact quote.
Garage Door Spring Repair Near Centreville – Our Service Area
We cover spring repair across Centreville and the surrounding towns, including Linton Hall, Gainesville, New Baltimore, Lansdowne, and Warrenton, plus Fair Lakes and Chantilly to the east. When a spring breaks and a door is jammed, our emergency service is set up for same-day calls, and our technicians aim to reach most nearby towns within a reasonable drive. For scheduled work, we’ll give you a window that fits your day. If you’re outside Centreville, our garage door spring repair page covers the Gainesville area, and Linton Hall neighbors can head to our garage door spring repair page for details.
Serving Centreville, VA – Our Local Coverage Area
We serve Centreville and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions – Garage Door Spring Repair in Centreville
Garage door spring repair is the replacement or adjustment of the coiled springs that counterbalance your door’s weight so the opener can lift it safely. It covers torsion springs (mounted on a shaft above the door) and extension springs (running along the side tracks). The job includes the new spring, any safety cables, and balancing the door afterward. Call (855) 497-3217 if you’re not sure which system your door has; we’ll tell you.
Most spring repairs take about an hour to ninety minutes on site, depending on whether it’s one spring or a pair and whether nearby parts need attention. The technician also spends time balancing the door and testing the safety reverse. If the spring is a matched pair or the setup is unusual, allow a little more. Call us for a realistic window on your door.
A typical spring repair in Centreville runs $180 – $340 for one spring, and a matched pair is usually replaced together at about twice that. Torsion versus extension, door height and weight, and any cable damage all affect where you land in that range. The quote is agreed before any work starts, so the price doesn’t change once the technician is on the door. Call (855) 497-3217 for an exact quote, with free estimates.
Yes, we service LiftMaster, Chamberlain, Genie, and Raynor equipment, plus other major brands like Clopay, Amarr, Wayne Dalton, and Craftsman. Each opener system and door brand has its own quirks in how it carries spring tension, and our technicians work with that rather than guessing. If your door has an opener that keeps reversing or a spring that failed early, that brand knowledge helps us get to the cause. Call (855) 497-3217 to book.
Yes, broken springs get same-day priority, and our emergency garage door service handles the calls where a broken spring has jammed the door open or trapped a car. A snapped spring leaves the door unsafe to run, so we don’t want you waiting a day for a fix. Call (855) 497-3217 and we’ll get a technician out as soon as possible.
We stand behind our work with a satisfaction guarantee, so if something isn’t right after the repair, reach out and we’ll sort it. The replacement spring itself is rated for a service life, and the technician can tell you what to expect for your door. We’ll go over the details when you book. Call (855) 497-3217 with any questions.
Clear the garage floor near the door and move anything out of the path so the technician has room to work, and avoid running the opener once the spring is broken. Keep the door closed and secured if you can. If a car is trapped inside, tell us when you book so we plan for it. For more on the wider service, our garage door repair Centreville page covers the full picture. Call (855) 497-3217 when you’re ready to schedule.
Schedule Your Garage Door Spring Repair Service in Centreville Today
A broken spring won’t fix itself, and running the opener on a dead spring makes things worse. Whether it’s torsion or extension, one spring or a pair, we’ll diagnose it, give you the price before the work starts, and get your door moving. Call (855) 497-3217 for a free, no-obligation estimate. Emergency calls welcome.
Written by the team at Garage Door Repair Centreville.